When forming the film features the master limited ability of this type of film to change shape – the greater the metallized film, the more layers in it than the thicker, the less susceptible it is forming. Molding is usually on the outside of the glass. Then, ready molded pattern is glued to the inside glass with special tools for toning. Check with marlon brando to learn more. Particular attention should be paid to Kant template. It should not be twisted, have nicks, in all its length must be the same, the optimum width of 1 mm edge. Along the lower edge of the glass film should not go back to back with a seal, because Operating film will cling to it when lifting / lowering of the glass and early or later will flake off.
Therefore, when installation of dubbing films on the glass side door to slip under the edge of the film seal, lining inside the door is usually on the upper otschelkivaetsya cannon, complete dismantling of the door casing is required only on sophisticated models of cars. Once the film is set on the glass, start to forcing out of her water and continued her packing. The final stage of installation is the elimination of minor errors, the final quality check and dried with Melt. Most small inaccuracies can be mounted subsequently corrected, but overall toning involves ensuring the most accurate installation of the film immediately, as it has in consequence can not be moved. There are only dotonirovanie or peretonirovka implying application of the new film. Process Installation dubbing of the film on the glass on the average car takes about 2-3 hours in the work of one master. However, in terms of completion of the toning of glasses, it occurs when the polymerization occurs adhesive layer, it proihodit, usually within three days. Full and final installation of the film on the glass is 30 (!) Days depending on weather conditions. Immediately after the installation of the film is considered normal appearance of a small number of small water bubbles and possible turbidity and divorces resulting from activation of the adhesive system, all these 'defects' disappear after complete installation of the film (up to 30 days!). After drying, the film smoothly and firmly snaps into the glass.